5/8″ 15.88mm Bundy Tube Copper Coated Bundy Pipe
Double wall copper brazed (Bundy welded) steel tube, outside diameter 15.88mm (i.e. 5/8″).
5/8″ 15.88mm Bundy Tube Copper Coated Bundy Pipe Read Post »
3/16 Bundy Tubing Bundy Pipe
Double wall Bundy welded steel tube.
Colorful Zinc Plated Bundy Tube for Automotive Hydraulic Brake Lines
Single wall or double wall Bundy tube zinc plated, trivalent chromated to colorful appearance.
Colorful Zinc Plated Bundy Tube for Automotive Hydraulic Brake Lines Read Post »
ASTM A254 7×0.7mm Bundy Welded (Brazed) Steel Pipe OD 7mm Wall 0.7mm
Now have plenty of stock of 7×0.7mm Bundy tubes, with copper coated both inside and outside, ASTM A254 7×0.7mm Bundy Welded (Brazed) OD 7mm Wall 0.7mm
ASTM A254 7×0.7mm Bundy Welded (Brazed) Steel Pipe OD 7mm Wall 0.7mm Read Post »
3 Meter Cut Bundy Tube OD .375″ Airshipped To UK
Requested urgently by a UK buyer, more than 70 kilograms of Bundy tube of OD .375″ were shipped directly from Xi’an to London by air.
3 Meter Cut Bundy Tube OD .375″ Airshipped To UK Read Post »
OD 1/4 inch 6.35mm Copper Brazed Steel Tubing Airshipped
A pallet of copper brazed steel tubing OD 1/4 inch was shipped by air to the client for urgent need. Tubes are packed in continuous coils, wrapped by plastic film, bundled by woven strips, and fixed on a steel pallet. The steel pallet is strong yet light (only 7 kilograms). That saves a lot of
OD 1/4 inch 6.35mm Copper Brazed Steel Tubing Airshipped Read Post »
Bundy Tube Burst Pressure Calculation Adopting Faupel Formula
This article introduces the theoretical calculation of Bundy tube burst pressure, based on Faupel Formula (burst pressure calculation for cylindrical container), and material properties shall be chosen in its respective material standards. The method can also be applies to most metal tube/pipe burst pressure calculations. Input Parameters D0, outside diameter of tube/pipe, in mm. t, thickness of
Bundy Tube Burst Pressure Calculation Adopting Faupel Formula Read Post »
GM Material Specification: EMS-99 Steel Tubing – Copper Brazed
1. Standard & Practices: To comply with all requirements of ASTM A254 2. Hardness: (On ID 90 degree from Seam) Rockwell 30T 55 Maximum. 3. Flatten & Bend Test: A section of the tubing 2-1/2″ minimum long shall stand being flattened between parallel plates until the inside walls are in contact. The flattened section shall
GM Material Specification: EMS-99 Steel Tubing – Copper Brazed Read Post »
